RTQ 3S r steel boilers must be installed in a dedi-
cated boiler room, with adequately sized vents, in com-
pliance with applicable laws and standards.
If at all possible, the boiler should be installed on a raised
base to prevent the burner fan sucking up dust.
b When installing the boiler, allow sufficient space
around it to access all safety and control devices
and to permit easy maintenance.
b If the specific weight of the gas supply to the burner
is greater than the specific weight of air, install all
electrical parts at least 500 mm above floor level.
a Do not install the boiler outdoors. It is not designed
to work outdoors and is not fitted with the necessary
automatic anti-frost systems to do so.
RTQ 91 3S MODELS ONLY
r RTQ 3S
boilers can be positioned:
On the floor or pedestal
The ideal solution for just heating installation.
b If you are installing the boiler without a pedestal, the
limited gap between the burner and the floor makes
it particularly important to keep the boiler room
clean.
On the heater
This is more practical with a combined installation (hea-
ting and hot water).
In this case, r 7300 boiler heater combinations are
used, as this heater has been specifically designed and
manufactur ed to support the weight of the boiler..
Place of installation
PLACE OF INSTALLATION
To Next Page
Loading...
