What should I do if the Riello SDH 3000 UPS does not come on and displays code A06 or A08?
If the Riello UPS doesn't turn on and shows code A06 or A08, check the temperature of the environment where the UPS is located. If it's below 0°C, increase the temperature above this minimum threshold.
What to do if the Riello UPS buzzer sounds continuously and the display shows codes F04, L04?
If the buzzer sounds continuously and the display shows one of these codes, it indicates that the temperature of the dissipators inside the UPS is too high. Check that the temperature of the environment where the UPS is located does not exceed 40°C.
What to do if the Riello SDH 3000 buzzer sounds continuously and shows codes F53, L53?
If the buzzer sounds continuously and the display shows one of these codes, it indicates a fault on one or more of the utilities powered by the UPS. Disconnect all the utilities, switch the UPS off and back on again, then reconnect the utilities one at a time to identify the faulty one.
Visual overview of the UPS unit, detailing front and rear aspects.
Detailed view of the UPS front panel display, buttons, and indicators.
Illustration and labels for the rear view of the battery box accessory.
Verifying all components are present in the UPS package upon receipt.
Specifies optimal environmental conditions for UPS and battery box placement.
Steps and considerations for connecting additional battery boxes to the UPS.
Procedure to configure the UPS with the correct battery capacity via software.
Instructions for configuring the UPS unit for vertical tower placement.
Steps for installing the UPS and battery box together in a tower configuration.
Guide for converting the UPS for installation in a standard 19-inch rack.
Steps for connecting and powering on the UPS for the very first time.
Procedures for starting and stopping the UPS from mains or battery power.
Explains various icons, statuses, and messages shown on the UPS LCD display.
Details on how to view UPS operating parameters like voltage, frequency, and load.
Guide to selecting and setting the UPS's operational modes (ON LINE, ECO, SMART ACTIVE).
How to use the manual bypass feature to power loads directly from mains.
Explanation of EnergyShare sockets for automatic load disconnection based on events.
Details on connecting the REPO and remote ON/OFF features via the terminal board.
Using PowerShield software for UPS management, monitoring, and automated operations.
Utilizing UPStools for UPS configuration and status display via USB or RS232.
Detailed table of configurable UPS functions and their available settings via UPStools.
Pinout and signal definitions for the RS232 communication port.
Information on expansion cards for additional communication capabilities like Ethernet or Profibus.
Step-by-step instructions for safely replacing the UPS battery pack.
Guide to identifying and resolving common problems with the UPS unit.
Comprehensive list of alarm codes, their meanings, and associated faults or anomalies.
Detailed technical data for all UPS models including input, output, and physical characteristics.
Technical details and dimensions for available Riello UPS Battery Box models.
General| Power Rating | 3000 VA / 2700 W |
|---|---|
| Topology | Online Double Conversion |
| Operating Temperature | 0-40°C |
| Output Voltage | 230 V |
| Output Waveform | Sinusoidal |
| Frequency Range | 50/60 Hz |
| Battery Type | Sealed Lead Acid |
| Communication Interface | USB, RS232 |
To Next Page