Rigol DG1032Z

RIGOL Contents
XIV DG1000Z User’s Guide
Contents
Guaranty and Declaration ......................................................................... I
Safety Requirement ................................................................................. II
General Safety Summary........................................................................... II
Safety Notices and Symbols ..................................................................... IV
Allgemeine Sicherheits Informationen ........................................................ V
Sicherheits Begriffe und Symbole ............................................................. VII
Care and Cleaning ................................................................................. VIII
Environmental Considerations ................................................................... IX
DG1000Z Series Overview ...................................................................... XI
Document Overview ............................................................................. XII
Chapter 1 Quick Start ........................................................................ 1-1
General Inspection ................................................................................. 1-2
To Adjust the Handle .............................................................................. 1-3
Appearance and Dimensions ................................................................... 1-4
Front Panel Overview ............................................................................. 1-5
Rear Panel Overview ............................................................................ 1-11
Power On and Inspection ...................................................................... 1-14
To Connect to Power ...................................................................... 1-14
Power-on ...................................................................................... 1-14
To Set the System Language ........................................................... 1-14
User Interface ...................................................................................... 1-15
Dual Channels Parameters Mode ..................................................... 1-15
Dual Channels Graph Mode ............................................................. 1-18
Single Channel View Mode .............................................................. 1-18
To Use the Built-in Help System ............................................................. 1-19
Chapter 2 Front Panel Operations ...................................................... 2-1
To Output Basic Waveform ...................................................................... 2-2
To Select Output Channel ................................................................. 2-2
To Select Basic Waveform ................................................................. 2-3
To Set Frequency/Period ................................................................... 2-4
To Set Amplitude/High Level ............................................................. 2-5
To Set Offset/Low Level .................................................................... 2-7
To Set Start Phase ........................................................................... 2-8
Align Phase ..................................................................................... 2-9
To Set Duty Cycle (Square) ............................................................. 2-10
To Set Symmetry (Ramp) ............................................................... 2-11
To Set Pulse Width/Duty Cycle (Pulse) ............................................. 2-12
To Set Leading/Trailing Edge Time (Pulse) ........................................ 2-13
To Enable Output ........................................................................... 2-14
Example: To Output Sine Waveform ................................................ 2-15