Rigol DG1032Z

RIGOL Chapter 2 Front Panel Operations
2-94 DG1000Z User’s Guide
Restore Default
Restore the instrument to its default state.
Press Utility  Set To Default  OK, the backlight of Utility turns off and switch
the instrument to Sine display mode. The default values are shown in the table below.
Note that the items marked with “*” are set at the factory and are related to the set
of the users and will not be affected by the Set To Default operation.
Table 2-4 Factory Default Values
Parameters
Defaults
Channel Parameters
Current Carrier Waveform
Sine
Output Impedance
HighZ
Output Load
50 Ω
Sync Output On
Sync Polarity Pos
Sync Delay 0s
Channel Output
Normal
Output Mode
Normal
Gated Polarity Pos
Range Auto
Waveform Sum Switch Off
Sum Source
Sine
Sum Frequency
1kHz
Sum Ratio
100%
Basic Waveform
Frequency 1kHz
Amplitude
5Vpp
Amplitude Unit
Vpp
Offset
0V
DC
Start Phase 0°
Square Duty Cycle 50%
Ramp Waveform Symmetry 50%
Pulse Duty Cycle
50%
Pulse Width
500μs
Pulse Leading Edge
20ns
Pulse Trailing Edge 20ns
Harmonic Type Even
Harmonic Order 2
Harmonic Phase (7)
0
°
Harmonic Serial Number
2
Harmonic Amplitude (7)
1.2647Vpp