Rigol DG4000 Series

Command System
In this chapter, the DG4000 series command subsystems are introduced in
alphabetical order (from A to Z).
COUNter Command Subsystem
COUPling Command Subsystem
DISPlay Command Subsystem
:HCOPy:SDUMp:DATA?
IEEE 488.2 Common Commands
MEMory Command Subsystem
MMEMory Command Subsystem
OUTPut Command Subsystem
PA Command Subsystem
SOURce Command Subsystem
SYSTem Command Subsystem
TRACe Command Subsystem

Explanation: in this command set, commands relating to some parameter (such as
frequency and amplitude) settings can be sent with units. The units supported by
these parameters and the default units are as listed in the table below.
