Rigol DG4000 Series

To Next Page

To Previous Page

RIGOL Chapter 1 Disassemble and Assemble

1-4

DG4000 Service Guide

Disassemble the Rear Metal Cover

Figure 1-3 Dsiassemble the Rear Metal Cover

Part Explanations:

① 4 BNC nuts and lock washers.

② 11 screws (M3*6 tors countersunk head) fixing the front metal panel and rear

metal cover.

Disassemble Steps:

1. Remove the 4 nuts and washers (①) at the BNC port at the rear metal cover using

the BNC socket.

2. Remove the 11 screws (②) fixing the front metal panel and the rear metal cover

using the screw driver (T10) (in the figure above, the positions of some screws

are not pointed out and please remove those screws according to their actual

positions).

3. Take off the rear metal cover gently and disconnect the cables connecting the

main board.

Tip

Insert the cables into the corresponding interfaces

on the main board before

assembling the rear metal cover.

②

Rear Metal Cover

②

①

Other manuals for Rigol DG4000 Series