RIGOL
© 2007 RIGOL Technologies, Inc.
User‟s Guide for DM3000 Series
Press return to New interface then press Done button, you have finished the
input work, then you can use this sensor reference immediately, or you can save it
into the built-in storage space or your U-disk for future work.
Figure 1- 49
Press Apply button, to use this reference value file.
Press Save to save the file.
Figure 1- 50
Press Save button, to finish the save operation.
Figure 1- 51
Press Apply button, to start the sensor measurement.
Figure 1- 52
(2). Press Edit button, to edit the saved sensor reference values.
(3). Press Load button, to load the saved sensor reference file.
(4). Press Disp button, to choose the value to be shown on the display interface.
(5). Press History, enter the menu shown below:
To Next Page
Loading...
