Rigol DM3061

RIGOL
© 2007 RIGOL Technologies, Inc.
User‟s Guide for DM3000 Series
1-28
To Measure Sensor
The DM3000 converts the sensor physical properties into electrical voltage,
resistance, current for measurement. So it needs the sensor name, sensor type,
sensor physical unit, sensor reference data, and arithmetic.
Figure 1- 37
Table1- 12 Sensor Building Options
New
Newly built sensor reference data file
Edit
Edit a sensor reference data file
Load
Load a sensor reference data file
Display
Set display mode
Steps:
1. Connect test leads as shown in Figure 1- 54, Figure 1- 55, red test leads to the
HI Terminal, black test leads to the LO Terminal.
2. Press to select the Sensor function.
3. Press New, the display shows:
Figure 1- 38
(1). In New function interface, press Prpty to edit the sensor Name, sensor Type and
physical characteristics of the sensor.