Rigol DM3061

RIGOL
© 2007 RIGOL Technologies, Inc.
User‟s Guide for DM3000 Series
2-53
External trigger
The multimeter receives a trigger signal from the “Ext Trig” at the rear panel.
Once at External trigger mode the other trigger is prohibited.
Manual trigger
Press under the Manual trigger mode to obtain continuous data.
The factory default trigger mode is Manual trigger.
Start delay
The start delay time refers to the time from the first sample to the start of the second
sample.
Press  Log  Start  Delay, the interface shows below.
Figure 2- 62 The Menu of Start Manner Interface
Table 2- 39 The Start Delay Menu Description
Function
Menu
Setting
Description
The set
value
The default value of delay time is 0s, use the
direction key to set the time needed.
Save all the changes, back to a higher level
menu.