RIGOL
© 2007 RIGOL Technologies, Inc.
User‟s Guide for DM3000 Series
2. Limit Measurement
Use the Limit test function to perform pass/fail testing with respect to specified
upper and lower limits. The limits can be set to any value between 0 and ± 120% of
the highest range of the current function. The upper limit must be positive than the
lower limit.
Press Limit, the display shows:
Figure 2- 15
Table 2- 12 Limit Measurement Menu Function Description
The range of Limit function:
(1). The limit value scope is 0%~± 120% of the current measurement range.
(2). The upper limit value should be always bigger than the lower limit value.
To Next Page
Loading...
