RIGOL Chapter 1 Calibration Notices
1-2 DP700 Calibration Guide
To Stop the Calibration
During calibration, you can stop the calibration in the following two ways:
Exit the calibration page by pressing keys or using the knob.
In the calibration page, use the Up arrow key or the knob to switch to the
"TestCal" tab, then use the Left/Right arrow key or the knob to switch between
tabs and exit the calibration page (For the save operation and precautions
during calibration, refer to Chapter 2 in this manual).
Turn off the instrument.
Press the Power key
to turn off the instrument.
When you stop calibration, the saved calibration data will not be lost. You do not
need to calibrate the items already calibrated again in the next calibration.
CAUTION
If you stop calibration when the instrument is writing the new calibration
factors into the internal non-volatile memory, you may lose all the
calibration factors and you need to perform the calibration for all the
required items again.
To Acquire the Calibration Service
RIGOL does not recommend users to perform manual calibration by themselves. If
calibration is required, please contact RIGOL customer service department or the
local distributor.
Recommended Calibration Devices
You are recommended to use the devices listed in Table 1-1 or other devices whose
performance specifications meet the "Performance Requirement" listed in Table 1-1.
Table 1-1 Recommended Calibration Devices
Device Performance Requirement Recommended Model
Digital Multimeter 6
/
2
DM3068
Test Probe
Connect the output terminals of
DP700 series and the input
terminals of the multimeter
--
To Next Page
Loading...
Need help?
General
