RIGOL
2-24 Copyright ©1998-2008 RIGOL Technologies, Inc.
User’s Guide for DS1000CA Series
IV. Using Vertical and
Use the vertical controls to display signal waveforms by adjusting the vertical
, the and , and setting the input parameters.
1. Using vertical
knob.
The vertical
control changes the vertical position of signal
waveforms in all channels (including MATH and REF). The resolution changes
according to the vertical level set. Pressing this knob will clear the channel offset
to zero.
2. Using vertical
knob.
The vertical
control changes the vertical sensitivity of signal
waveforms in all channels (including MATH and REF). If the Volts/Div is set to
“Coarse”, the waveform scales in a 1-2-5 step sequence from 2 mV to 10 V. If the
Volts/Div is set to “Fine”, it scales to small steps between the coarse settings.
3. Channels would be adjustable by the vertical
and only
when they are selected.
4. During the vertical positioning, a position message is displayed on the left bottom
of the screen, in the same color as the corresponding channel. The unit is V
(Volts).
To Next Page
Loading...
