Rigol DS4000 Series

Contents RIGOL
MSO4000/DS4000 User’s Guide XXIII
SINGLE ......................................................................................... 1-23
Multi-function Knob ........................................................................ 1-24
Navigation Knob ............................................................................ 1-24
Default ......................................................................................... 1-25
Print ............................................................................................. 1-25
Function Keys ................................................................................ 1-26
Record .......................................................................................... 1-27
LOGIC ANALYZER........................................................................... 1-28
User Interface ...................................................................................... 1-29
To Use the Security Lock ....................................................................... 1-36
To Use the Built-in Help System ............................................................. 1-37
Chapter 2 Vertical System Setting ...................................................... 2-1
To Turn the Analog Channel On/Off ......................................................... 2-2
To Adjust the Vertical Scale .................................................................... 2-3
To Adjust the Vertical Position ................................................................. 2-4
To Specify the Channel Coupling ............................................................. 2-5
To Specify the Bandwidth Limit ............................................................... 2-6
To Set the Probe ................................................................................... 2-7
Passive Probe ................................................................................. 2-8
Active Probe ................................................................................... 2-9
Tek Probe ...................................................................................... 2-11
To Specify the Input Impedance ............................................................ 2-12
To Turn Waveform Invert On/Off ............................................................ 2-13
To Specify the Vertical Reference ........................................................... 2-13
To Specify the Amplitude Unit ................................................................ 2-14
To Set the Channel Label....................................................................... 2-15
To Set the Delay Calibration................................................................... 2-17
Chapter 3 Horizontal System Setting .................................................. 3-1
To Adjust the Horizontal Time Base ......................................................... 3-2
To Adjust the Horizontal Position ............................................................. 3-3
To Specify the Time Base Mode .............................................................. 3-4
Y-T Mode ....................................................................................... 3-4
X-Y Mode ....................................................................................... 3-5
Roll Mode ....................................................................................... 3-9
To Turn Delayed Sweep On/Off .............................................................. 3-10
To Specify the Horizontal Reference ....................................................... 3-13
www.calcert.com sales@calcert.com1.800.544.2843
0
5
10
15
20
25
30