ring Alarm - Setting Up Ring Alarm Devices; Three-Step Device Setup; Caution on Tab Removal During Setup; Device Identification Codes

. Set up your Alarm devices.
For the easiest setup, complete all three steps for each device before moving on to the next one. Use the app
and this guide to help you position your Alarm devices to improve your home security.
If you need to take a break, you can close the app and finish adding security devices later. When you’re ready
to resume setup, open the Ring app and tap Set Up a Device.
Setting up your Ring Alarm security devices involves three steps:
Don’t pull out all of the tabs at once! It can make setting up your Ring
Alarm a lot more complicated. Wait until you’re ready to set up a certain
device, then only pull its tab when the app prompts you.
Understanding device codes.
Your Ring Alarm kit comes with a suite of devices.
Each has a unique QR code and -digit code on
the back.
These let you easily identify devices while working
in the app. These codes can usually be found on the
rear of devices, as shown in these sample images.
Back of Motion Detector Back of Contact Sensor
Connect
the device to
your Ring Alarm.
Configure
its settings
as needed.
Install
the device.
98