8 9
Uninstall your existing
doorbell button.
Remove your doorbell from the
wall. Disconnect the wires. Make
sure they don’t fall back inside your
wall so you can access them later.
Remove the faceplate.
Grasp the bottom of the faceplate
and pull to remove.
Install the included Corner Mount.
(optional)
The Corner Mount can angle your
Ring Doorbell to improve motion
detection and provide a better view.
Mark two mounting holes on your
wall through the slots on your
Corner Mount (fig 1).
If you are replacing a Ring Doorbell,
align the two small screw holes with
two of the existing holes in your
wall (fig 2).
(Skip to page 15 if you don’t plan
on using the Corner Mount.)
fig. 1 fig. 2
To Next Page
Loading...
