- 10 -
OPERATION WITH UNIVERSAL TEMPERATURE CONTROLLERS
Using 1 Universal Temperature Controller
Press the ON/OFF button on the Temperature Controller.
The ON indicator will glow on the Temperature
Controller. This indicates that the hot water unit is
ready to supply hot water when a tap is open.
Adjusting Temperature
Simply press the HOTTER ∧ or COOLER ∨
button until the required temperature is displayed
on the Digital Monitor.
To operate the hot water unit, simply turn any hot
water tap on. This will automatically light the
burner providing hot water. The red IN USE
indicator will glow on the Temperature Controller.
If the set temperature is either to hot or cold Press
the HOTTER ∧ or COOLER ∨ button until the
desired temperature is reached
CHECK WATER TEMPERATURE BEFORE USE.
A parent should always check the temperature before a child is placed in contact with hot water
.
CAUTION
Consumer safeguards: With the hot water tap open and a temperature of 43°C or higher selected, if the
temperature is decreased to below 43ºC, and then raised again the maximum available temperature
will be 43°C
in addition tem
erature ‘
riorit
’ cannot be transferred between controllers.
NOTE
- 5 -
To Next Page
Loading...
Need help?
General
