Rinnai RPC26MC User Manual

Rinnai 12 Portable Room AC OIM
CONTROL PANEL
1� ON/OFF Button 2� Filter Reset Button
3� Fan Speed Button 4� Temperature Button
5� Mode Selection Button 6� Sleep Mode Button
7� Timer Button 8� Swing Button
IMPORTANT
Before operating this appliance ensure that the location, installation and condensation
requirementshavebeenmet,refertoinstallationinstructionsstartingonpage19fordetails.
Forthebestcoolingresultsensurethattheltersareclean,referpage17fordetails.
Whentheapplianceispluggedandthepowerpointisturnedonasinglebeepwillbeheardand
thecoolairoutletlouvrewillcycleopenandclosedonce,thisisnormal.
BASIC OPERATION
There are four basic operational modes available, these are AUTO, COOL (chilled air operation), DRY (chilled and
dehumidied operation) and FAN (fan only operation).
BASIC OPERATION CONTROL PANEL
AUTO
1� Press the ON/OFF button (1).
2� Press the mode selection button (5) until the AUTO mode indicator is illuminated.
The table below describes the relationship between room temperature and modes of operation when set to Auto.
RoomTemperature SetTemperature Operation Mode
≥ 24°C 24°C COOL Mode
< 24°C 24°C FAN mode
3� Use fan speed button (3) to select the desired fan speed (AUTO, LOW, MED or HIGH).
4� Press the ON/OFF button (1) to stop operation.
1235678 4
TEMP� Indicator
OPERATION

Rinnai RPC26MC Specifications

General

Brand	Rinnai
Model	RPC26MC
Category	Air Conditioner
Language	English