Rinnai 18 Portable Room AC OIM
SAVE A SERVICE CALL
SYMPTOM POSSIBLE CAUSES POSSIBLE SOLUTIONS
Appliance will not operate�
Not plugged into power� Plug into power�
Power switch OFF. Switch power ON�
Timer Function set. Wait or reset timer function.
Power to Appliance but it will not start.
After switching o the
appliance there may be a 3
minute delay before it may
be re-started.
Wait 3 minutes.
Room temperature is lower
than the set temperature.
Adjust the set temperature
to be lower than the room
temperature�
P1 appears on the display. Drain the water from the
drain outlets.
The air conditioner does not generate
enough cool air�
The air intake lters are
blocked
Clean air lters.
The set temperature is too
high�
Adjust the set temperature to
a lower temperature�
Drafts from open windows
and doors.
Close windows and doors
in the area you want to be
cooled�
Other heat sources in the
room�
Remove or turn o heat
sources.
Cooling space too big. Operate the appliance within
the required cooling capacity.
Too noisy or vibrating.
Operating surface not level Move the appliance to level a
operating surface.
Splashing sound.
High level of condensate
being generated�
This is normal. This appliance
has a pump that evaporates
some condensate through
the exhaust duct.
WHEN TO CALL FOR SERVICE
SYMPTOM CAUSE
There is a burning smell and a
strange sound coming from the
unit�
When operated if a circuit breaker
(safety, ground) is thrown or a fuse
is blown.
Turn o the air conditioner, and contact Rinnai.
CARE & MAINTENANCE
To Next Page
Loading...
Need help?
General
