Rinnai RUS75e series User Manual

KCM Series Manual 53


Water temperatures over 125° F (52° C) can cause severe burns or scalding
resulng in death.
Hot water can cause rst degree burns with exposure for as lile as:
3 seconds at 140° F (60° C)
20 seconds at 130° F (54° C)
8 minutes at 120° F (49° C)
Children, disabled, or elderly are at highest risk of being scalded.
Feel water before bathing or showering.
A maintenance display or status monitor is provided in the front panel to indicate operang status and error
codes. This water heater requires a minimum ow rate to operate. This rate can be found on the specicaon
page in this manual. In some cases when you are not geng hot water or if the water alternates between hot
and cold, it is due to the water ow being below or close to the minimum ow rate. Increasing the ow rate
should resolve these problems in these cases.
If you are experiencing issues with higher temperature sengs, then reduce the temperature seng. Selecng a
temperature closer to that which is actually used at the faucet will increase the amount of hot water being
delivered to the faucet, due to less cold water mixing at the xture.
 Before operang, smell all around the appliance area for
gas. Be sure to smell next to the oor because some gas
is heavier than air and will sele on the oor.
 Keep the area around the appliance clear and free from
combusble materials, gasoline, and other ammable
vapors and liquids.
 Always check the water temperature before entering a
shower or bath.
 Do not use this appliance if any part has been under
water. Immediately call a licensed professional to
inspect the appliance and to replace any part of the
control system and any gas control which has been
under water.
 Should overheang occur or the gas supply fail to shut
o, turn o the manual gas control valve to the
appliance.
 Do not adjust the DIP switch unless specically
instructed to do so.
 Do not use an extension cord or an adapter plug with
this appliance.
 Any alteraon to the appliance or its controls can be
dangerous and will void the warranty.
 If you install this water heater in an area that is known
to have hard water or that causes scale build-up the
water must be treated and/or the heat exchanger
ushed regularly. Rinnai provides a “Scale Control
System” as an accessory that oers superior lime scale
prevenon and corrosion control by feeding a blend of
control compounds into the water supply. Damage and
repair due to corrosive compounds in the air is not
covered by warranty.
 Keep the air intake locaon free of chemicals, such as
chlorine or bleach, that produce fumes. These fumes
can damage components and reduce the life of your
appliance. Damage and repair due to scale in the heat
exchanger is not covered by warranty.
WARNING

Rinnai RUS75e series Specifications

General

Brand	Rinnai
Model	RUS75e series
Category	Water Heater
Language	English