Rinnai V Model Series User Manual

14 V53De Manual
Installaon of Temperature Controller
Controller Locaon
Cable Lengths and Sizes
• The controller should be out of reach of small
children.
• Avoid locaons where the controller may become
hot (near the oven or radiant heater).
• Avoid locaons in direct sunlight. The digital
display may be dicult to read in direct sunlight.
• Avoid locaons where the temperature controller
could be splashed with liquids.
• Do not install in locaons where it can be
adjusted by the public.
The cable for the temperature controller should be a
non-polarized two-core cable with a minimum gauge
of 22 AWG. The maximum cable length from each
controller to the water heater depends on the total
number of wired controllers connected to the water
heater.
Number of Wired
Controllers
Maximum Cable Length for each
Controller to Water Heater
1 328  (100 m)
2 164  (50 m)
3 or 4 65  (20 m)
Turn the power o. Do not aempt to connect the
temperature controllers with the power on. Although
the controller is a low voltage device, there is 120 volt
potenal next to the temperature controller
connecons inside the unit.
Do not connect the temperature controller to the
120VAC terminals provided for the oponal solenoid
drain valves.
WARNING / AVERTISSEMENT
Conguraons
A maximum of 4 temperature controllers can be
installed for a water heater or bank of water heaters.
This includes the controller built into an indoor water
heater. Controllers can only be wired in parallel.
Controllers cannot be wired in series.
If 4 MC-601-US controllers are installed,
simultaneously press the Priority and ON/OFF buons
on the fourth controller unl a beep sounds.
Residenal Applicaons: MC-601-US-BK,
MC-601-US-W
Wire controllers in parallel

Rinnai V Model Series Specifications

General

Brand	Rinnai
Model	V Model Series
Category	Water Heater
Language	English