ARBOTOM
®
- Manual 16
In this window the following setting can be made:
Project, Location, Tree, Tree species, Date, North
Tree species: Different tree species have a different wood anatomy and therefore vary their
physical properties. These different properties have an influence on the way
the impulse travels thought the wood. Therefore it is absolutely necessary to
indicate the tree species.
North: To orient the north arrow.
Height: Height of measuring level above ground. Especially needed in case of 3D
measurements.
Position: Shows position of Sensor along the measuring tape.
Radius-Difference: Deviation from circularity, to be inserted manually.
Bending: The bending defines how much the outer line between the sensors will be
curved. This bending is an optical adjustment only and will not influence the
outcome of the measurement.
To Next Page
Loading...