LOG
The Gardtec 350 has a 50 event Log that records system events in the order that they
occur. To view the Log proceed as follows:-
1) With the Control panel in the DAY mode (Unset) enter the Master code. The
exit tone will sound.
2) Before the exit time expires Press NO. The exit tone will silence and the
RReemmoovvee LED will flash.
3) Press NO Twice and the LLoogg LED will flash as shown in Fig 7.
Fig 7.
4) Press YES to use the LLoogg option. The display shown is the last event. To
view the previous event press NO, to move to the next event press YES.
5) To escape out of the LLoogg option press 0 and the display will show as in Fig 7.
6) If you wish to return to DAY mode press 0 again.
Whilst in the LLoogg mode the LEDs may display the following:-
All LEDs on indicates an alarm, press NO to view the cause.
DAY LED with Z1, Z2 or Z3 LEDs indicate unset by user 1, 2 or 3
Rapid flashing DAY LED. System was Set. Slow flashing DAY LED System was Part
set
If all the LEDs are flashing this indicates an alarm occurred. Pressing NO to move to
the previous event will show the cause of alarm
If the zone LED(s) are illuminated without the alarm indication the zone was removed.
Page 8
GARDTEC 350
Users Manual
300 Series
GARDTEC
POWER
DAY
Z1
Z2
Z3
Z4
Z5
TAMPER
REMOVE
TEST
LOG
CHIME
PROGRAM
ENTER
To Next Page
Loading...
