CHIME
The Chime function may be turned On or Off by the Master user. Before Chime can be
turned on the Chime zones should have been programmed by your engineer.
To turn the Chime On or Off proceed as follows:-
1) With the Control panel in the DAY mode (Unset) enter the Master code. The
exit tone will sound.
2) Before the exit time expires Press NO. The exit tone will silence and the
RReemmoovvee LED will flash.
3) Press NO Three times and the CChhiimmee LED will flash as shown in Fig 8.
Fig 8.
4) Press YES to change the status of the CChhiimmee. The Display will show as Fig 9.
Fig 9.
Page 9
GARDTEC 350
Users Manual
300 Series
GARDTEC
POWER
DAY
Z1
Z2
Z3
Z4
Z5
TAMPER
REMOVE
TEST
LOG
CHIME
PROGRAM
ENTER
300 Series
GARDTEC
POWER
DAY
Z1
Z2
Z3
Z4
Z5
TAMPER
REMOVE
TEST
LOG
CHIME
PROGRAM
ENTER
To Next Page
Loading...
