SETTING THE SYSTEM
To Fully Set the system proceed as follows:-
1) Enter a valid User code. (The DAY LED will flash followed by the exit tone.
Any zones violated during exit will change the
exit tone and the appropriate L.E.D will indicate).
2) Leave the premises via the
authorised exit route.
Note: To abort setting during exit time re-enter the code.
PART SETTING THE SYSTEM
To Part Set the system proceed as follows:-
1) Enter a valid User code. (The DAY LED will flash followed by the
exit tone).
2) If Part Set 1 is required Press 1 or (The DAY LED will flash slowly. Zones
programmed as Part 1 will be removed)
If Part Set 2 is required Press 2 or (The DAY LED will flash slowly. Zones
programmed as Part 2 will be removed)
If Part Set 3 is required Press 3 (The DAY LED will flash slowly. Zones
programmed as Part 1 and Part 2 will
be removed).
3) Leave the premises via the authorised exit route (or retire to an unprotected
area).
Note: If any of the above part sets have been programmed as silent by your
engineer the setting will be silent with a single beep as the system final-
ly sets.
Page 2
GARDTEC 350
Users Manual
To Next Page
Loading...
