Page 6
GARDTEC 350
Users Manual
4) Press the key corresponding to the zone you wish to remove followed by the
YES key (a comfort tone will be generated if all is okay). If you make a mis-
take and remove the wrong zone repeat the operation from step 3 but press
NO after the zone number.
5) If you wish to remove more zones repeat from step 3.
6) When you have finished removing the required zone(s) press the 0 key to
escape programming mode.
Note: This operation should be carried out each time you wish to remove
individual zones. If you remove the same zone(s) on a regular basis ask
your engineer to put them in a part set suite.
To Next Page
Loading...
