9
5. Make sure that there is a minimum clearance of 2.5cm between the gate and the opener and that the opener
and the Post Pivot Bracket are not binding in both the gate-open and gate-closed positions. If there is not at least
2.5cm of clearance or if the opener and the Post Pivot Bracket are binding, rotate the Post Pivot Bracket and/or
move the Post Bracket Assembly to obtain the minimum clearance and eliminate the binding. When the minimum
clearance has been obtained and any binding has been eliminated, place the M8 x 30 bolt through the aligned
holes in the Post Bracket and the Post Pivot Bracket.
To Next Page