To Next Page
A
Ann LewisSep 9, 2025
What to do if my Rivacold Air Conditioner has an unsealed discharge valve?
- AAustin JenkinsSep 9, 2025
If your Rivacold Air Conditioner has an unsealed discharge valve, seal it.
What to do if my Rivacold Air Conditioner has an unsealed discharge valve?
If your Rivacold Air Conditioner has an unsealed discharge valve, seal it.
What to do if the condenser is dirty in my Rivacold Air Conditioner?
If the condenser of your Rivacold Air Conditioner is dirty, the suggested solution is to clean it.
What to do if my Rivacold Air Conditioner has a clogged suction filter?
If your Rivacold Air Conditioner's suction filter is clogged, you should clean or replace it.
What to do if my Rivacold Air Conditioner has ice formed on expansion valve needle?
If ice has formed on the expansion valve needle of your Rivacold Air Conditioner, remove the ice.
What to do if my Rivacold Air Conditioner has clogged liquid pipes?
If the liquid pipes in your Rivacold Air Conditioner are clogged, clean them.
What to do if my Rivacold Air Conditioner has condensing water temperature too high?
If the condensing water temperature is too high in your Rivacold Air Conditioner, lower the condensing water temperature.
What to do if my Rivacold Air Conditioner has a clogged expansion valve filter?
If the expansion valve filter is clogged in your Rivacold Air Conditioner, clean or replace it.
What to do if my Rivacold Air Conditioner has a by-pass shut off valve opened or perforated rupture disk?
If the by-pass shut off valve is opened or the rupture disk is perforated in your Rivacold Air Conditioner, inspect and repair the by-pass shut off valve or replace the rupture disk.
What to do if my Rivacold Air Conditioner has a dirty filter on oil return?
If the filter on oil return is dirty in your Rivacold Air Conditioner, clean or replace it.
What to do if my Rivacold Air Conditioner has clogged discharge pipes?
If your Rivacold Air Conditioner has clogged discharge pipes, clean the clogged discharge pipes.
General| Refrigerant | R410A |
|---|---|
| Power Supply | 220-240V/50Hz/1Ph |
| Cooling Capacity | 2.6 kW |
| Air Flow | 500 m³/h |
| Noise Level (Indoor) | 38 dB(A) |
Details lifting, fixing units, pipe/cable passage, and clearance requirements.
Refers to drawings and documents for evaporator installation.
Covers refrigerating connections, suction line, oil return, and vacuum procedures.
Details the process of charging the system with refrigerant and checking for leaks.
Covers pressure switches, relief valves, and electrical connection requirements.
