38
Beam shaper
Four beam shapers with continuous rotation in both directions
Frost lters
Two separate,variable frost lters (light and medium)
Zoom
Linear motorized zoom
Focus
Motorized focus
Hot-Spot control
Motorized control of lamp position in order to change intensity of beam centre
Strobe
Strobe eect with variable speed (max.15 ashes/sec.)
Pan/Tilt
Pan movement range 540°
Tilt movement range 265°
16 bit movement resolution
Pan/Tilt electronic motion stabilizer
Automatic Pan/Tilt position correction
Remotely controllable speed of pan/tilt movement for easy programming
Movement control: tracking and vector
Pan/tilt-lock mechanism
Dimmer
Smooth dimmer from 0 - 100 %
Control
Graphic touch screen for xture setting and addressing
Gravitation sensor for auto screen positioning
Battery backup of the touch screen
Readout xture and lamp usage, receiving DMX values, temperatures, etc
Built-in analyzer for easy fault nding, error messages
Remotely switching on/o the lamp
Black out while head moving or prism wheel changing
Stand-alone operation
3 user editable programs, each up to 100 steps
Supported protocols: USITT DMX 512, RDM, ArtNet, MANet, MANet2, sACN
Support of RDM (Remote Device Management)
2 DMX modes (34, 39 control channels)
Wireless DMX/RDM module (only for wireless DMX version)
Compliance with USITT DMX-512 (1986 & 1990) and 512-A
Full DMX delity and frame integrity
Auto sensing of DMX frame rate and frame size
<5ms DMX latency
Operational frequency range of 2402-2480 MHz
Producer: LumenRadio
Connection
DMX in/Out: 3-pin and 5-pin XLR
Ethernet: 2 x RJ 45
Power IN: Neutrik TrueOne NAC3MPX
Power OUT: Neutrik TrueOne NAC3FPX
To Next Page
Loading...
