Roberts Blutune T2 - Prune Stations - DAB; Operating Your Radio - FM

10
Station list
Scan
Manual tune
Prune invalid
DRC
Station order
DAB
Prune Invalid
Removes all
invalid stations
No Yes
Tuning
Select / Info / Snooze
Menu
Mode
Tuning
Select / Info / Snooze
Prune stations - DAB
If you move to a different part of the country, some of the stations which were listed may
no longer be available. Also, from time to time, some DAB services may stop broadcasting,
or may change location or frequency. Stations which cannot be found, or which have
not been received for a very long time are shown in the station list with a question mark.
The Prune stations function will delete the marked DAB stations from your station list.
1. When in DAB mode, press Menu.
2. Choose 'Prune invalid' and then choose 'Yes' to cause the invalid station names to
be removed from the station list.
3. If you do not wish to prune stations choose 'No' in step 2 above.
Note: If you have moved your radio to a different part of the country you should also carry
out a search for new stations (please see the section 'Finding new stations' on page 8).
Operating your radio - FM
1. Carefully extend the telescopic aerial. Press On/Standby to switch on the radio.
2. Press Mode until the 'FM' mode is selected.
3. Rotate the Tuning control clockwise. The displayed frequency will increase.
Apply a long press on the Tuning control to carry out an auto-tune. Your radio
will scan in an upwards direction (low frequency to high frequency) and stop
automaticallywhenitndsastationofsufcientstrength.
4. The display will show the frequency of the signal which has been found. If RDS
information is available, after a few seconds the display will show the radio station
name. If you only hear hiss or interference, simply apply a long press on the
control to scan further.
5. To scan down in frequency, rotate the Tuning control anti-clockwise and then apply
a long press on the control. Your radio will scan the FM band in a downwards
direction (high frequency to low frequency).
6. When the waveband end is reached your radio will recommence tuning from the
opposite waveband end. Adjust the Volume.
7. To switch off your radio press On/Standby.
103.40MHz
FM 16.34
FM