5
Menu
Mode
Tuning
Select / Info / Snooze
Menu
FM
AUX
Bluetooth My Music
Navigation controls
This page describes the basic means of controlling your Blutune T2 radio. Detailed
instructions for each operating mode are given in the later sections of this book.
1. Pressing and releasing the On/Standby button brings your radio out of the
Standby mode if running from the mains or switches it on if using batteries.
Pressing and releasing the On/Standby button while the radio is in use will cause it
to return to the Standby mode with the clock display when running from the mains, or
will switch it off after a short delay when running on batteries.
2. Pressing the Mode button gives you access to each of the operating modes in turn:
DAB radio, FM radio, Auxiliary Input, Bluetooth and Music Player.
Alternatively, press the Mode button and then turn the Tuning/Select control clockwise
or anti-clockwise to highlight the desired menu item then press the control to select
that item.
3. Pressing the Menu button will access the menu system.
4. Many operations require the user to make a selection from the menu. This is done using
the Tuning/Select control. Turn the control clockwise or anti-clockwise to highlight the
desired menu item then press the control to select that item.
If there are more than six items in a menu, then the display will automatically scroll up
or down so that the additional items become visible.
If there are many items in a menu, then the radio allows the menu to 'wrap around'
in either direction. This can make it easier to reach items at the end of a long menu,
such as a list of DAB radio stations.
5. If an error is made when navigating the menus, it is generally possible to go back to
a higher level menu by pressing the Menu button.
6. Pressing the Tuning/Select control allows the display of information relating to the
radiostationormusiclebeingplayed.
Note: In this booklet press always means press and release. If it is required to give a
long press on a button this is described as apply a long press and the button should
be held down for 2 to 3 seconds until the radio has responded.
Scan
Manual tune
Prune invalid
DRC
Station order
System settings
DAB
Time/Date
Brightness
Language
Snooze
Alarms
Factory reset
System settings
To Next Page
Loading...
