Roberts Blutune T2 - Display Backlight Dimmer; Language Function

27
Tuning
Select / Info / Snooze
Menu
Dimmer
Language function
Yourradio'smenuscanbeconguredtoadifferentlanguage.
1. Press On/Standby to switch on your radio.
2. Press Menu. Choose 'System settings' and then 'Language'. The current language
is indicated with a tick.
3. Choose your desired language. The display will change to the chosen language.
4. Press Menu as needed to exit.
Display backlight dimmer
The brightness of the display can be adjusted for when the radio is in standby or when
in use. If you use the unit in the bedroom, you may prefer a lower standby brightness
level than the standard setting. There are six standby brightness levels and six levels
for when the radio is in use.
To change the current brightness setting please follow these steps.
1. If your radio is in the standby mode or playing, press the Dimmer button to choose
the High, Medium High, Medium, Medium Low, Low or Off dimmer setting.
2. Alternatively to adjust the brightness using the menu, press Menu.
3. Choose 'System settings' and then 'Brightness'.
4. To adjust the display brightness when the radio is switched on select 'Normal'.
To adjust the display brightness when the radio is in Standby select 'Standby'.
Press Tuning to enter the selected brightness adjustment mode.
5. Choose the High, Medium High, Medium, Medium Low, Low or Off dimmer setting.
Note that the backlight is almost completely off at the Off setting.
6. Press Tuning to set the level. Press Menu as needed to exit.
When the radio is in standby and powered from the mains pressing any button (except
the Dimmer button) or the rotary controls will cause the radio to switch to the 'High'
brightness level for a few seconds. This is so that if the standby brightness level is
set to Low or Off, it is still possible to see the time when needed.
Brightness
Language
Snooze
Alarms
Factory reset
Info
System settings
Normal
Standby
Backlight
Normal
High
Medium High
Medium
Medium Low
Low
Off
Brightness
Language
Snooze
Alarms
Factory reset
Info
System settings
Language
English
Dansk
Français
Deutsch
Italiano
Norsk