Roberts Blutune T2 - Using the Radio for the First Time

6
Aux In
1
Using the radio for the rst time
1. Placeyourradioonaatsurface.
2. Carefully extend the telescopic aerial. The aerial should be fully
extended and positioned vertically for optimum reception.
3. Plug the mains adaptor into the DC input socket located on the
rear of your radio (marked 'DC In') ensuring that the plug is pushed
fully into the socket.
4. Plug the other end of the mains adaptor into a standard mains
socket outlet and switch on the wall socket.
5. Thedisplayontheradiowillbrieyshowastartupscreen.During
thistimetheradioisscanningtondaDABradiosignal.Aftera
short time the current time will appear on the display.
6. If no signal is found, it may be necessary to relocate your radio
to a position giving better reception. You should then carry out a
scantondstations,see'Finding new stations' on page 8.
The AC adaptor should be disconnected from the mains supply and
from the radio when not in use.
IMPORTANT: The mains adaptor is used as the means of connecting
the product to the mains supply. The mains socket and any multi-way
mains block used for the product must remain accessible during
normal use. In order to disconnect the product from the mains, the
mains adaptor should be removed from the mains socket completely.
Use only the mains adaptor provided with the product, or a genuine
replacement provided by Roberts Radio. The use of alternative adaptors
will invalidate the guarantee.