Roberts Blutune T2 - Cancelling Alarms

24
Setting the alarm clock - cont.
6. The alarm can be set to buzzer, DAB radio or FM radio. For whichever radio mode is
selected, the radio alarm may be set to any of the stations which have been stored as
presets or to the station most recently listened to.
Choose the 'Alarm Sound' option for the alarm then select either 'Buzzer' or the required
radio mode.
7. If setting the alarm to the radio option, choose the 'Preset' option then choose either
the radio station 'Last Listened' to, or from presets 1- 30.
Note: You can only set the alarm to use a preset which has already been stored.
8. Choose the 'Volume' option. The radio uses the saved volume setting for each alarm
when it sounds. Use the Tuning control to set the required volume.
9. In order to store the alarm settings rotate Tuning until 'Alarm Save' is highlighted. Press
Tuning to store the alarm settings. Your radio will show 'Alarm Saved'.
Active alarms are shown using small alarm indicators
1
2
and the corresponding alarm
number at the bottom of the playing displays and on the clock display when in Standby.
Note: If you make a mistake at any point while setting the alarms, it is generally possible
to go back to the previous screen using the Menu button.
Tuning
Select / Info / Snooze
Menu
DAB
FM
Buzzer
Alarm 1 Sound
Alarm 1 Volume
15
Alarm Mode: Daily
Alarm Time: 06:30
Alarm Sound: Buzzer
Alarm Volume: 15
Alarm Save
Alarm 1
ALARM 1
SAVED !
Alarm Mode: Once
Alarm Time: 06:30
Alarm Sound: DAB
Preset: Last Listened
Alarm Volume: 14
Alarm Save
Alarm 1
When the alarm sounds
The alarm will sound at the selected times for up to 120 minutes unless cancelled. The volume
usedforthealarmwillbespeciedduringthealarmsettingprocedure.Whenyourradioissetto
wake by the radio alarm, your radio will switch to the selected radio station. If the radio cannot
receivethespeciedDABradiostation,thebuzzer willbeusedinstead.Note: If the radio is
switched on because of a radio alarm you can control basic functions such as the volume control.
Whenthealarmactivatesitwillstartsoftlyandgraduallyincreaseinlevel.Thealarmiconwillash
on the screen and the radio will automatically switch back to standby mode when the selected
alarm duration has elapsed.
Cancelling alarms
1. Whilst an alarm is sounding, press On/Standby to cancel the alarm.
2. If the snooze feature is not required, then setting the snooze option to 'OFF' will allow other
controls also to be used to cancel an alarm (see page 25).
Alarm
Buzzer
1