Roberts Ortus Time - Sleep Timer Function; Automatic Clock Update

14
Sleep function
Your clock radio can be set to turn off after a preset time has elapsed. The
sleep timer can be set to between 15 and 90 minutes. Ensure your clock
radio is switched on.
1. Apply a long press on the On/Off/Sleep button. The sleep symbol
ZLOOÀDVKRQWKHGLVSOD\
2. Rotate Tuning to select the desired sleep time. The sleep setting will
increase in increments from 15 up to 90 minutes. A further increment will
cause the sleep timer to be set to OFF which will cancel the sleep function.
3. Press Tuning. The display will exit the sleep options. Your clock radio will
switch off after the preset sleep time has elapsed.
4. To view the remaining sleep time, apply a long press on the On/Off/
Sleep button.
5. To cancel the sleep timer and switch off your clock radio before the chosen
sleep time has elapsed, press On/Off. To cancel the sleep timer without
switching off your clock radio, set the sleep timer to the OFF setting.
Sleep
Automatically updating the clock
Your clock radio will usually set the clock time using the DAB signal. Alternatively
you may set the clock manually.
1. Press On/Off to switch on the clock radio.
2. Press Menu/Mode.
3. Rotate and press Tuning to select 'SYSTEM', 'TIME', 'UPDATE' and then
choose an update option from, 'DAB' or 'NONE'.
4. Press Tuning WRFRQ¿UP\RXUFKRLFH
5. The clock radio will set its time according to the information received.
If a signal is not found you should then either position the clock radio or its aerial
so that a signal can be received, or revert to manual clock mode (see page 15).
Mode
Sleep