16
Software version
The software version display cannot be altered and is just for your reference.
1. Press On/Off to switch on the clock radio.
2. Press Menu/Mode.
3. Rotate and press Tuning to select 'SYSTEM' and then 'SW VER'.
4. Press Tuning to display the software version.
5. Press Menu/Mode as needed to exit.
Mode
Sleep
Display backlight dimmer
The brightness of the display can be adjusted for when the clock radio
is in standby. If you use the unit in the bedroom, you may prefer a lower
standby brightness level than the standard setting. There are four standby
brightness levels.
To change the current standby brightness setting please follow these steps.
1. When the clock radio is in Standby, press the Dimmer button to choose
from the High, Medium, Low or almost Off dimmer setting.
When the radio is in standby pressing any button (except the dimmer button)
or the rotary controls will cause the radio to switch to the 'High' brightness
level for a few seconds. This is so that if the standby brightness level is
set to Low or almost Off, it is still possible to see the time when needed.
The display backlight will always use the high setting whenever the radio
is switched on.
To Next Page
Loading...
