Roberts Ortus Time - Manual DAB Tuning

6
Manual tuning - DAB
Manual tuning allows you to tune your clock radio to a particular DAB
frequency in Band III. Any new stations found will be added to the station
list. This function can also be used to assist the positioning of the aerial or
WKHFORFNUDGLRWRRSWLPLVHUHFHSWLRQIRUDVSHFL¿FFKDQQHORUIUHTXHQF\
1. Repeatedly, apply a long press on Menu/Mode until the 'DAB' mode
is selected.
2. Press Menu/Mode.
3. Rotate Tuning until the display shows 'MANUAL'. Press Tuning.
4. Rotate Tuning to select the desired DAB channel. Press Tuning to
tune to the chosen frequency.
5. If a signal is present, this will be indicated on a signal strength display.
The minimum signal marker (
) shows the minimum signal strength
needed for good DAB reception.
6. When a DAB signal is found, as shown by the signal indicator chevrons,
any new radio stations found with this signal will be added to the list
stored in the clock radio. Press Menu/Mode to exit.
Dynamic Range Control (DRC) settings - DAB
The DRC facillity can make quieter sounds easier to hear when your clock
radio is used in a noisy environment. The default DRC setting is 0.
1. When in DAB mode, press Menu/Mode.
2. Rotate Tuning until 'DRC' is displayed. Press Tuning.
3. Rotate Tuning to select the required DRC setting.
DRC 0 - DRC is switched off, Broadcast DRC will be ignored. DRC
1/2 - DRC level is set to 1/2 that sent by broadcaster. DRC 1 - DRC is
set as sent by broadcaster.
4. Press Tuning WRFRQ¿UPWKHVHWWLQJNote: Not all DAB broadcasts use
the DRC function. If the broadcast does not provide DRC information,
then the DRC setting in the clock radio will have no effect.
Mode