Roberts Ortus Time - Operating DAB Radio; Using the Radio Buttons

4
Operating your clock radio - DAB
1. Press the On/Off button to switch on your clock radio.
 :KHQ¿UVWVZLWFKHGRQWKHFORFNUDGLRZLOOEHLQ'$%PRGH$IWHUHDFKXVH
the clock radio will remember the mode used and then switch on in that
mode the next time it is used. If the clock radio has been used before, the
last used station will be selected.
 ,I WKLVLV WKH ¿UVWWLPH WKHFORFNUDGLR KDVEHHQXVHG DVFDQRI WKH%DQG
III DAB channels will be carried out (depending on whether scanning was
already completed in standby mode). During the scanning process the display
will show the progress of the station search. The number on the right of the
display is the number of stations that have been found.
 :KHQ WKH VFDQ LV FRPSOHWHG WKH ¿UVW VWDWLRQ LQ QXPHULFDOSKD RUGHU
$=ZLOOEHVHOHFWHG7KH ¿UVW VWDWLRQLQWKHOLVW RIVWDWLRQVIRXQG
during scanning will be played. The display will show the station name.
5. If no signals are found then it may be necessary to relocate your clock radio
WRDSRVLWLRQJLYLQJEHWWHUUHFHSWLRQ<RXVKRXOGWKHQFDUU\RXWDVFDQWR¿QG
stations as described on page 5.
• Your clock radio has an indicator
on the display to indicate the strength
of the DAB radio signal being received.
Note:KHQ¿UVWVZLWFKHGRQWKHFORFNUDGLRZLOOVHWWKHYROXPHWRDPRGHUDWHO\
high level, in case the broadcast is very quiet. After you have set the volume,
the clock radio will remember the setting that you have applied for the next time
that it is used.
Sleep
Using the buttons
Most operations on the clock radio are performed by a simple short press of a button.
A few operations require a longer press of a button. In this case the instructions will tell you to apply a long press, and the button should be held
down for 2 or 3 seconds, until the clock radio has responded. An example of this is applying a long press to the Menu / Mode button to change the
operating mode of the clock radio.