Roberts Ortus Time - Initial Setup and First Use

3
8VLQJWKHFORFNUDGLRIRUWKH¿UVWWLPH
 3ODFH\RXUFORFNUDGLRRQDÀDWVXUIDFH
2. Carefully fully extend the wire aerial located on the rear of your clock
radio. Place the wire aerial so that it is as straight as possible extending
either above or below the clock radio.
3. Plug the mains adaptor into the DC input socket located on the rear of
your clock radio (marked 'DC') ensuring that the plug is pushed fully
into the socket.
4. Plug the other end of the mains adaptor into a standard mains socket
outlet and switch on the wall socket.
5. The display will show 'WELCOME' for a few seconds. During this time
WKHUDGLRLVVFDQQLQJWR¿QGD'$%UDGLRVLJQDO$IWHUDVKRUWWLPHWKH
current time and day will appear on the display and the clock hands
will be set to the correct time.
6. If no signal is found, '0:00' will be displayed. It may be necessary to
relocate your clock radio to a position giving better reception. You
VKRXOGWKHQFDUU\RXWDVFDQWR¿QGVWDWLRQVDVGHVFULEHGRQSDJH
7KH$&DGDSWRUVKRXOGEHGLVFRQQHFWHGIURPWKHPDLQVVXSSO\DQGIURP
the clock radio when not in use.
IMPORTANT: The mains adaptor is used as the means of connecting the
product to the mains supply. The mains socket and any multi-way mains
block used for the product must remain accessible during normal use. In
order to disconnect the product from the mains, the mains adaptor should
be removed from the mains socket completely.
Use only the mains adaptor provided with the product, or a genuine
replacement provided by Roberts Radio. The use of alternative adaptors
will invalidate the guarantee.
Ant