Roberts Ortus Time - Pruning DAB Stations; Operating FM Radio

7
Operating your radio - FM
1. Carefully extend the wire aerial. Press On/Off to switch on the clock radio.
2. Repeatedly, apply a long press on Menu/Mode until 'FM' mode is selected.
3. Rotate Tuning clockwise and then apply a long press on the Tuning
control. Your clock radio will scan in an upwards direction (low frequency to
KLJKIUHTXHQF\DQGVWRSDXWRPDWLFDOO\ZKHQLW¿QGVDVWDWLRQRIVXI¿FLHQW
strength.
4. After a few seconds the display will update. The display will show the
frequency of the signal found. If the signal is strong enough and there is
RDS data present then the clock radio will display the station name.
5. Rotate Tuning anti-clockwise and then apply a long press on the Tuning
control. Your clock radio will scan the FM band in a downwards direction
(high frequency to low frequency). When the waveband end is reached your
radio will recommence tuning from the opposite waveband end. Adjust the
Volume. To switch off your clock radio press On/Off.
Mode
Mode
Prune stations - DAB
If you move to a different part of the country, some of the stations which were
listed may no longer be available. Also, from time to time, some DAB services
may stop broadcasting, or may change location or frequency. Stations which
cannot be found, or which have not been received for a very long time are shown
in the station list with a question mark. The Prune stations function will delete the
marked DAB stations from your station list.
1. When in DAB mode, press Menu/Mode.
2. Rotate Tuning until 'PRUNE' is displayed. Press Tuning.
3. Rotate Tuning until 'Y' is displayed. Press Tuning to cause the invalid station
names to be removed from the station list.
4. If you do not wish to prune stations choose 'N' in step 3 above.
Note: If you have moved your clock radio to a different part of the country you
should also carry out a search for new stations (please see the section 'Finding
new stations' on page 5).
Sleep