Roberts R1 - Information; Factory Reset Procedure

37
Information
Factory reset
If you wish to completely reset your speaker to its initial state this may be
performed by following this procedure. By performing a factory reset, all user
entered settings will be erased.
1. To reset your speaker press and hold the Reset button for approximately
10 seconds or until the Power, Network Status and Mode indicators light
EULHÀ\
2. The speaker should then clear its stored settings and restart. A full reset
ZLOOEHSHUIRUPHGDQGWKHVSHDNHUZLOOUHVWDUWDVLI¿UVWSOXJJHGLQ$IWHUD
further 10 seconds the Network Status indicatorZLOOÀDVKVORZO\
 <RXPD\WKHQUHFRQQHFW\RXUVSHDNHUWR\RXUQHWZRUNXVLQJWKH81'2.
app (see page 7 to 9).
4. Alternatively you can reset your speaker from the 'Settings' screen in the
UNDOK app.
In case of malfunction for any reason, reset the product as described above to resume normal operation. It
may be necessary in some cases to disconnect the mains power, then reconnect power after 10 seconds.
In case of malfunction due to electrical fast transient (burst), reset the product as above (reconnection of the
power source may be required) to resume normal operation.
When connecting the speaker to a router with an Ethernet cable, shielded cable is highly recommended. The
communication could be interrupted temporarily or noise may occur if using un-shielded cable and under strong
local interference. Normal communication will resume automatically when the interference signal is removed.
1
Standby Network Mode
Standby Network Mode
Speaker ready to connect