Robin EC03ER User Manual

3-4-5 CYLINDER COVER
(1) Install cylinder cover to cylinder.
M5 X 14mm screw and washer 2pcs.
M5 X 20mm screw and washer * * * lpce.
I .TIGHTENING TORQUE I
30 - 40 kgf cm
295 - 390 N cm
30 - 35 IN-LB
3-4-6 LEAD VALVE AND INSULATOR
(1) Install gasket lead valve, with gasket, insulator and wire bracket to crankc
M5 X 20mm screw and washer 2pcs.
M5 X 22mm screw and washer 2pcs.
395 - 490 N cm
ase.
r Apply sealant (THREE BOND # 1360) to screws.
I I
3-4-7 CARBURETOR AND AIR CLEANER
(1) Install carburetor gasket and carburetor, then mount air cleaner base.
(2) Set cleaner element to cleaner cover.
(3) Set cleaner cover to cleaner base. (See page 6, Fig. 5.)
M6 X 65mm screw and washer 2pcs.
TIGHTENING TORQUE
40 - 50 kgf cm
395 - 490 N cm
35 - 40 IN-LB
3-4-8 MAGNETO (C.D.I.)
(1) Install woodruff key to crankshaft.
(2) Install flywheel to crankshaft.
M6 X 16mm bolt, spring washer and washer 1 pce.
I TIGHTENING TORQUE I
110 - 130 kgf *cm
1080 - 1270 N-cm
95 - 110 IN-LB
I I
(3) Install ignition coil to crankcase.
M5 X 20mm screw 2pcs.
- 17 -

Robin EC03ER Specifications

General

Brand	Robin
Model	EC03ER
Category	Engine
Language	English