Robin EH12 - Page 27

15
Starter pulley
16
Flywheel
I
17 1 Charge coil
(Option)
Procedures
(1) Remove starter pulley from flywheel.
Place socket wrench
on flywheel fastening
nut and strike tip of the lever with
hammer. Refer to the illustration below.
(See Fig.
5-9.)
14mm nut lpc. (EH12,EH17)
18mm
nut -.-. lpc. (EH25)
M6 X 14mm flange bolt - - 1 pc. (EH2.5)
(1) Remove flywheel from crankshaft.
(2) Remove key from crankshaft.
(See
Fig. 5-1 1 .)
(1) Remove charge coil.
M6 X 20mm Screw 2pcs.
Fig. 5-9
F
LYWHEEL
Remarks
Do not place bar or screw
driver
in flywheel fin to
loosen flywheel nut.
Use flywheel puller as
illustrated
below.
(See Fig. 5-10.>
Tool
19mm (EH12,17)
24mm (EH25)
socket wrench
~~ ~~
Flywheel puller
w
Fig. 5-1 0
Fig. 5-12
- 23 -