Robin EH30V - Page 19

tep
4
control
Procedures
(1) Remove speed control assembly from
crank
case. Then governor spring from
governor lever.
6
q5 X 16mm Bolt -... 2pcs.
(2) Remove choke rod from speed
control
assembly, then remove choke rod from
choke shaft of the carburetor.
Remarks
Memorize or mark the
govenor spring hooking
position.
1
Governor (1) Remove governor lever from governor
lever shaft.
6
q5 x 25mm Bolt *-a. lpce.
(2) Remove rod spring and governor rod
from governor lever, then remove rod
spring and governor rod from throttle
shaft
of the carburetor.
Tool
10mm Box wrench
10mm
Box wrench
Ppcs.
GOVERNOR SHAFT
/
ROD SPRING
Fig. 19
- 15 -