Robin EH30V - Page 23

Step Part to remove Procedures Remarks Tool I
I
Ignition coil
(1) Remove spark plug cap from spark
plug
and grommet from blower housing.
(2) Disconnect kill switch wire which
comes out from ignition coil from kill
switch on speed control
assy.
6 0 x 30mm Bolt **-* 2pcs.
(3) Remove ignition coil from crankcase.
GROMMET
KILL SWITCH WIRE
6 + BOLT AND WASHER : 2pcs.
IGNITION COIL
&$
I
Fig. 24
- 19 -