(6)
If spring escapes from starter case when
disassembling recoil, recoil and assemble in
the following manner.
a) Make
a
spring
holder
for
the spring with
thin wire
of
which diameter
is
smaller than
the one
of
spring housing in starter case
and twist the end together.
Wind the power spring inside the wire ring
starting with the outer loop
of
the spring
(See Fig.
80.)
b)
Place the spring assembly over the recess
in the housing,
so
that the hook in the
outer loop
of
the spring
is
over the tab
in the housing (See
Fig.
77.)
Fig.
80
Carefully press the spring out the wire ring and into the recess in the housing.
(7)
Lubricate the rotating parts, sliding parts and spring with heat resistant grease or mobile
oil
when reassembling recoil and prior to long term storage.
-
51
-
To Next Page
Loading...
