Robin R1700i Service Manual

– 34 –
Recoil starter
hundle
Guide
Overflow pipe
Case body
Control panel
Mount
Case body
Tightening torque : 3.0
-
4.0 N
・
m
30
- 40 kgf
・
cm
(2.2
- 2.9 ft
・
lbs)
Tightening torque : 3.0 - 4.0 N
・
m
30
- 40 kgf
・
cm
(2.2
- 2.9 ft
・
lbs)
Tightening torque : 2.0-3.0 N
・
m
20-30 kgf
・
cm
(1.5
- 2.2 ft
・
lbs)
5-4-21 Case body, control panel
Attach the case body (left and right). Install the bottom
part of the case body and the mount together.
M6 x 18mm Flange bolt : 4pcs.
5-4-22 Recoil starter and guide
Install the guide of the starter hundle.
Install the guide and starter hundle after they are
pushed through the mounting hole from inside of the
case body.
M4 x 10mm Tapping screw : 1pcs.
Insert the overflow pipe through the hole in the bottom
of the case body.
Attach the upper part of the case body.
M6 x 25 Screw and Washer : 2pcs.
Install the control panel into the case body.
M4 x 14mm Screw :4pcs.
M5 x 8mm Screw :4pcs.
NOTE: Avoid gaps in the upper part of the case body
when installing.
NOTE: Install the bottom part of the case body
correctly.

Robin R1700i Specifications

General

Brand	Robin
Model	R1700i
Category	Portable Generator
Language	English