10 V0913 E 300 / E 2800
English Deutsch
Starting up the machine (Fig.6)
Turn the main switch (1) to position “1”.
To start the main saw motor push the start button (2).
The scorer motor is started by pushing the start button (3); this is only possible with the main saw
motor running.
By pushing the emergency stop- button (4) both the scorer- and main saw motor are stopped.
Mounting of the E300 sliding table (Fig.7)
The position of the sliding table relative to the machine is factory set and needs no further
adjustments.
The adjustment bolts C are height setting bolts set at factory. To ensure a clean and neat cut the
sliding table has to be set 100 % parallel to the sawblade.
To correct the parallelism between sliding table and sawblade use bolts A.
After adjustment tighten all the bolts previously loosened.
Fig.6
Fig.6 bis
Fig.7
C
D
C
B
A
A
To Next Page
Loading...
