EasyManuals Logo

Robomow RC306 User Manual

Robomow RC306
57 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
20
4.3.3 Setting a Narrow Pass
ANarrowPassisdenedasapaththatconnectstwozonesofthelawn.ThepathenablesRobomowtodrive
between the zones while following the wire, but prevents the mower from crossing between them while mowing
the inner area of the zones. The pass has to be at least 1.2 m (4 ft.) wide to allow Robomow to drive through it.
If the pass is wider than 2 m (6.5 ft.),
There is NO need for any special setting of the Perimeter Wire. Skip to section 4.3.4. Otherwise, you need to follow
the instructions given below in order to set up a Narrow Pass.
Scan the code to view a video explaining how to
set a narrow pass
If the passage is NARROWER than 1.5m and longer then 2m,
the following wire installation needs to be done – “dual-square installation”:
1. DenetheentrytotheNarrowPass–thepointyouwantthemowertostartdrivingtowardstheSub-Zone.
2. 50 cm (20 inches) from the Narrow Pass entry, set a Perimeter Island (refer to 4.3.2) as shown in the picture
above.
3. Continue to lay the wire along the edge at a proper distance (depending on the edge type) until coming back
to the Narrow Pass entry from the Sub-Zone side.
4. Measure 50cm (20 inches) from that point and lay another Perimeter Island with the same dimensions.
5. After completing the setup of the wire in the Sub-Zone, make sure you keep 10 cm (4 inches) between the wire
and the islands on the way back to the Main Zone.
10cm
10cm
2 Wires under
same peg
28cm
Sub-Zone
Main-Zone
50cm
50cm
Min. 50cm
The above setup allows Robomow to drive along the wire to reach the Sub-Zone. However, while mowing each
zone individually, it will not cross over to the other zone.

Table of Contents

Other manuals for Robomow RC306

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Robomow RC306 and is the answer not in the manual?

Robomow RC306 Specifications

General IconGeneral
TypeRobotic lawn mower
Cutting width280 mm
Cutting system-
Recommended lawn area600 m²
Maximum cutting height60 mm
Minimum cutting height15 mm
Grass collecting volume- L
Battery typeLiFePO4
Power sourceBattery
Charging time1 h
Battery voltage26 V
Weight and Dimensions IconWeight and Dimensions
Depth460 mm
Width630 mm
Height210 mm
Weight11400 g

Related product manuals