Robomow RC306 User Manual

39
EN
Screen Seng Descripon Opons
P025
SmartMow
Edge Overlap
(Default =
10)
• Allows adjusting the degree of overlapping with lawn’s edge,
when performing the smooth and continuous turns in SmartMow
mode.
• Increasing this value will cause a higher overlapping with lawn’s
edge (for better mowing results), but at some point may prevent
the mower from performing a smooth turn.
• Ifthereismorethanonezonedened,thissettingmaybesetper
zone or for the entire lawn (‘All’).
5-30
P026
TurboMow
(Default = OFF)
• TurboMow feature allows faster and stronger mowing of a high
grassduringtherstcutoftheseason.
• When a mower is operated for the rst time, or if the Factory
Defaults (“Out of the Box” settings – see Section 5.2) are invoked,
this feature is automatically set to ON to provide better mowing
results already after the initial mowing cycle. At the end of the
initial mowing cycle, the feature will be automatically disabled (set
to OFF).
• This menu allows to activate TurboMow feature manually. ‘U094’
(“Raise mowing height when activating the TurboMow mode.”)
will be displayed. At the end of the cycle the feature will be
automatically deactivated (set to OFF).
• When the TurboMow feature is activated, the initial mowing cycle
will be longer and noisier than the next mowing cycles.
On/OFF
P027
RoboHome
(Default = OFF for
all models except
‘RC312 Pro S’)
• Allows proper rain detection when RoboHome accessory is
installed.
• When set to ON, Robomow will drive back from the Base Station
to sense the rain before beginning an operation. If rainy conditions
are sensed, Robomow will drive back to the Base Station and
postpone the operation.
On/OFF
P028
External Base
(Default = OFF)
• In case the Base Station is installed outside the perimeter of your
lawn (“External Setup”, see section 3.2.3), this option sets the
distance (in meters) from the Base Station that your Robomow
needs to drive before starting to mow your lawn.
OFF/1/2/
3/4/5
6.4.3 Robomow App Settings
Using the Robomow App you will have access to additional menu options that are not available on the mower,
such as an option to set an additional window of Inactive Hours.
6.5 Operaon in a Non-Base Zone (using a Perimeter Switch)
In order for Robomow to operate in a Non-Base Zone, the Perimeter Switch has to be turned on and the mower
should be inside the active perimeter area.
• Verify that the Perimeter Switch is connected to the zone to be mowed.
• Press the ‘ON’ button to turn on the Perimeter Switch.
• Drive/carry Robomow to the lawn area. Refer to “Transportation” part of Section 1.3 for carrying instructions.
• To initiate the operation, choose the operation mode you want, press the arrow buttons to choose the Zone
you want to mow and press OK to start operation (refer to Section 6.3).
• When Robomow completes the mowing, it will stay on the lawn. You will have to drive/carry it back to its place
for charging.

Robomow RC306 Specifications

General

Type	Robotic lawn mower
Cutting width	280 mm
Cutting system	-
Recommended lawn area	600 m²
Maximum cutting height	60 mm
Minimum cutting height	15 mm
Grass collecting volume	- L
Battery type	LiFePO4
Power source	Battery
Charging time	1 h
Battery voltage	26 V

Weight and Dimensions

Depth	460 mm
Width	630 mm
Height	210 mm
Weight	11400 g