Robomow RC306 User Manual

45
EN
Display Message Probable Cause/Event Correcve Acons
0022
Check mowing
motor
- Mowing motor has faced over-
current for too long in the Base
Station before starting the operation.
- CAUTION – Switch Off the Safety Switch
before checking the blade.
- Remove the mower from the Base Station.
Inspect the blade for foreign material or debris
preventing rotation.
0023
Check power - See E4 in the above table
0026
Base problem
- Robomow fails to enter the Base
Station several consecutive times.
- Adjust the Base Station position.
- Clean the contacts with a brush or piece of
cloth.
0027
Start Elsewhere
- Drive wheel motors have been
working under severe load during
automatic or manual operation.
- Check to insure the mower is not stuck,
causing the drive wheels to slip.
- Check the ground around the mower for holes
or indentations. Fill with ground and level off.
- Check if the drive wheels are free to rotate
and nothing is blocking them.
- Move the mower away from this particular
location and restart operation.
0028
Cross Outside
- The Perimeter Wire is too close to
the edge.
- The lawn slope is too steep.
- Robomow does not succeed to
turn in place at the edge and it
causes the mower to slip out of the
designated area.
- Robomow has slipped out of the
Perimeter Wire lope because of
sloping area or wet grass.
- Remove the wire towards the inner part of the
lawn.
- Do not include this area because of its steep
slopes.
- Fill holes and pits in the ground.
- Increase the cutting height.
0030
Start Inside
- Automatic operation is initiated
while the robot is placed out of the
Perimeter Wire loop.
- Place the mower inside the lawn and renew
the operation.
0031
Stuck in place - See E1 in the above table
0060
Check mowing
hours (%)
- The mowing hours % value you
have set is too high for your lawn
area.
- Decrease the mowing hours % you have set
for the zone(s) in your lawn.
0061
Decrease
Inactive Time
- See E8 in the above table

Robomow RC306 Specifications

General

Type	Robotic lawn mower
Cutting width	280 mm
Cutting system	-
Recommended lawn area	600 m²
Maximum cutting height	60 mm
Minimum cutting height	15 mm
Grass collecting volume	- L
Battery type	LiFePO4
Power source	Battery
Charging time	1 h
Battery voltage	26 V

Weight and Dimensions

Depth	460 mm
Width	630 mm
Height	210 mm
Weight	11400 g